ST1033 - ⅓ HP Submersible Sump Pump

Installed price: $439.00
Installed price includes normal installation. Upgrades, difficult access, irregularities, code compliance may be extra.
Includes Dual Float Switch and standard controller DFC1
Features
• Cast iron/cast aluminum construction
• Energy efficient permanent split capacitor (PSC) motor
• Piggy-back dual float switch with protective cage
• Continuous duty rated
• Stainless steel shaft
• Dual carbon/ceramic seals
• 18-month warranty
• Water cooled - no oil

Energy Savings
• Permanent split capacitor (PSC) motor and dual ball bearings allow for lower amp draw
• ST Series will save on average of $57 per year (assumes industry average of 9.5 amps for ⅓ HP pumps and 10.5 amps for ½ HP pumps, $0.12 per kilowatt hour and running time of 5 minutes per hour)
• Pump will pay for itself in just a few years
• The ST1033 pumps 6.1 gallons per watt hour (G/Wh) used, which is 172% more efficient than the competitive average of ⅓ HP sump pumps.
Download Spec Sheet

S3033 - ⅓ HP Submersible Sump Pump

Installed price: $529.00
Installed price includes normal installation. Upgrades, difficult access, irregularities, code compliance may be extra.
Includes Dual Float Switch and deluxe controller DFC2
Features:
• Cast iron / stainless steel construction
• Energy efficient permanent split capacitor (PSC) motor
• Piggy-back dual float switch with cage
• Deluxe controller monitors power conditions and sounds an alarm when:
- AC power is out or circuit breaker is tripped
- Float has been raised for more than 10 minutes indicating service is needed - 9-volt battery needs replacement
• Continuous duty rated
• Stainless steel shaft
• Dual carbon/ceramic seals
• 10' Pump cord
• Output terminals for connection to a security system or auto-dialer
• 3-year warranty
• Water cooled - no oil

Energy Savings
• Permanent split capacitor (PSC) motor and dual ball bearings allow for lower amp draw
• S3 series will save an average of $55 per year (assumes industry average of 9.5 amps for HP ⅓ pumps and 10.5 amps for ½ HP pumps, $0.12 per kilowatt hour and running time of 5 minutes per hour)
• Pump will pay for itself in just a few years
• The S3033 pumps 6.2 gallons per watt hour (G/Wh) used, which is 180% more efficient than the competitive average of ⅓ HP sump pumps.
• The S3050 pumps 7.6 gallons per watt hour (G/Wh) used, which is 185% more efficient than the competitive average of ½ HP sump pumps.
Download Spec Sheet

S5033 - ⅓ HP Submersible Sump Pump

Installed price: $695.00
Installed price includes normal installation. Upgrades, difficult access, irregularities, code compliance may be extra.
Includes Dual Float Switch and deluxe controller DFC2
Features
• Continuous duty construction
• Cast iron housing
• Energy efficient permanent split capacitor (PSC) motor
• Stainless steel shaft
• Upper and lower ball bearings
• Dual carbon ceramic seals with additional third shaft seal
• Dynamically balanced cast iron impeller
• Stainless

Energy Savings
• Permanent split capacitor (PSC) motor and dual ball bearings allow for lower amp draw
• S5 series will save an average of $55 per year (assumes industry average of 9.5 amps for HP ⅓ pumps and 10.5 amps for ½ HP pumps, $0.12 per kilowatt hour and running time of 5 minutes per hour)
• Pump will pay for itself in just a few years
• The S5033 pumps 7.4 gallons per watt hour (G/Wh) used, which is 230% more efficient than the competitive average of ⅓ HP sump pumps.
• The S5050 pumps 6.1 gallons per watt hour (G/Wh) used, which is 130% more efficient than the competitive average of ½ HP sump pumps.
Download Spec Sheet

PHCC Pro Series PS-C11 Combination Sump Pump System

Installed price: $1295.00
Installed price includes normal installation. Upgrades, difficult access, irregularities, code compliance may be extra.
Features
• Pre-Assembled for quick and easy installation
• Energy efficient permanent split capacitor (PSC) motor
• Continuous duty rated
• Dual float switches on primary and backup pumps
• Automatically switches to battery power when AC fails
• Backup pump will assist primary pump if excessive amounts of water are entering the sump
• Detects irregularities, sounds an alarm, and pinpoints problems and solutions on control panel
• Maintains and recharges battery automatically
• Alarm can be silenced during a power outage
• 3-year warranty
• Water cooled (no oil to leak)

Energy Savings
• PS-C11 will save on average $57 per year (assumes industry average of 9.5 amps for ⅓ HP pumps and 10.5 amps for ½ HP pumps, $0.12 per kilowatt hour and running time of 5 minutes per hour)
Download Spec Sheet

PHCC Pro Series PS-C33 Combination Sump Pump System

Installed price: $1695.00
Installed price includes normal installation. Upgrades, difficult access, irregularities, code compliance may be extra.
Features

• Pre-Assembled for quick and easy installation
• Energy efficient permanent split capacitor (PSC) motor
• Continuous duty rated
• Dual float switches on primary and backup pumps
• Automatically switches to battery power when AC fails
• Backup pump will assist primary pump if excessive amounts of water are entering the sump
• Detects irregularities, sounds an alarm, and pinpoints problems and solutions on control panel
• Maintains and recharges battery automatically
• Alarm can be silenced during a power outage
• Output terminals for connection to a security system or auto-dialer (PS-C33 only)
• Can accommodate two (2) B2200 batteries for 16 hours of continuous pumping (PS-C33 only)
• 3-year warranty
• Water cooled (no oil to leak)

Energy Savings
• PS-C33 saves on average $55 per year
(assumes industry average of 9.5 amps for ⅓ HP pumps and 10.5 amps for ½ HP pumps, $0.12 per kilowatt hour and running time of 5 minutes per hour)
Download Spec Sheet

PHCC Pro Series Standby Batteries B-2200

Installed price: $298.00
Installed price includes normal installation. Upgrades, difficult access, irregularities, code compliance may be extra.
Pro Series batteries are standby batteries. They are made to be drained and recharged, and they will last longer and perform better than an automotive or deep cycle battery in this application.
The matching standby batteries for our 2400, 2200, 1730 and 1000 sump pump systems have a unique construction that enables them to:
• Run the pumps longer... for more hours per charge
• Remain viable for more years... normally five to seven years
• Accommodate the fluid sensor for the Pro Series sump pump systems
Download Spec Sheet

PHCC Pro Series 1000 Battery Backup Sump Pump System

Installed price: $795.00
Installed price includes normal installation. Upgrades, difficult access, irregularities, code compliance may be extra.
Includes battery install onto existing sump pump.
Features
• Dependable 1000 GPH, continuous-duty, submersible pump
• Pumps 1000 GPH at a 10-foot lift
• Stainless steel shaft, rulon seal, and rustproof housing provide long-lasting, reliable operation
• Trickle charger maintains the battery at full charge
• System continuously monitors the battery and power conditions to ensure dependable operation and sounds an alarm when:
- The AC power is out or the circuit breaker has blown
- The battery fluid is low and water needs to be added
- The pump was activated
- The battery is discharged, defective or the terminals need cleaning
• Alarm can be silenced
Download Spec Sheet

PHCC Pro Series 2400 Battery Backup Sump Pump System

Installed price: $1240.00
Installed price includes normal installation. Upgrades, difficult access, irregularities, code compliance may be extra.
Includes battery install onto existing sump pump.
Features
• Automatically switches to battery power when AC fails
• Recharges automatically
• Monitors system conditions and alarms when:
- Battery needs water, is discharged or needs to be replaced
- Battery cable is loose or corroded
- Power plug is disconnected, fuse is blown or circuit breaker is tripped
- Pump is clogged or broken
- Backup pump has been activated
• Alarm can be silenced during a power outage
• Displays percentage of power remaining in the battery
• Runs pump weekly to test for proper operation
• Can run directly on AC power
• Output terminals for connection to a security system or auto-dialer - Let the system call you
• Accommodates up to two (2) B2200 batteries for 16 hours of continuous pumping
Download Spec Sheet

PHCC Pro Series Water Alarm

Installed price: $149.00
Installed price includes normal installation. Upgrades, difficult access, irregularities, code compliance may be extra.
Water damage is costly and frequently leads to other problems... Just as the smoke alarm helps detect smoke, a water alarm can help detect water.
The PHCC Pro Series Water Alarm detects water leaks before they cause costly property damage or let mold grow. Simple water leaks from water heaters, sink drains, broken washing machine hoses (the number one cause of water damage in homes), clogged air conditioner drain tubes and leaky or broken pipes are immediately detected, resulting in quick corrective measures dramatically lowering damage, clean-up time and money.
Place a water alarm wherever there is a risk of water damage - utility room, laundry room, kitchen, bathroom or basement.
The water alarm will sound when as little as 1/32" of water reaches the sensor. Includes 6´ of sensor wire for remote monitoring. Wire can be extended to over 100´.

Dependable Protection
Solid state circuitry is extremely sensitive and reliable
110dB alarm can be heard throughout the house
Extended Life
Alarm will sound up to three days
Battery will last 24-48 months
Easy to Use
Install a 9V alkaline battery (not included) and place the alarm where water could cause damage or extend the sensor to the floor or into the sump pit.
Accidents happen...
Water heaters wear out and leak
Pipes break

Deluxe Dual Float Controller

Installed price: $187.00
Installed price includes normal installation. Upgrades, difficult access, irregularities, code compliance may be extra.
There are two types of controllers that use the Dual Float Switch:
Deluxe Dual Float Controller (Model #DFC2) The Deluxe Controller monitors pump and power conditions, and sounds an alarm when a problem is detected. The warning signals are described below. In addition, it begins the pumping cycle when either float rises ¼", and runs the pump an additional 10 seconds after the float returns to its original position. This controller (model #DFC2) is included with all S3 Series and S5 Series pumps.

Deluxe Controller Warning Signals When a warning alarm sounds, a light will appear on the front panel of the controller indicating which problem has been detected:
• AC power is out - sounds an alarm when the power is out, the pump has accidentally been unplugged, or the circuit breaker has been tripped
• The system is operating -a light blinks continuously indicating that the controller is plugged in and operating
• 9-volt battery low or slide switch is OFF - indicates when it's time to replace the battery or reminds you to move the slide switch back to the ON position
• Pump or float problem - sounds an alarm when the float has been raised for 10 minutes continuously, an indication that there is a potential pump or plumbing problem
• Remote terminal - provides connection to a home security system or remote dialer.
Download Spec Sheet

PHCC Pro Series Ejector Series Pumps

Installed price: $695.00
Installed price includes normal installation. Upgrades, difficult access, irregularities, code compliance may be extra.
E7055VS - ½ HP submersible sewage pump
Features
• Handles 2" solids through a 2" discharge
• Energy efficient permanent split capacitor (PSC) motor
• Rated for continuous duty use
• Dual carbon/ceramic seals plus one Buna N seal
• Upper and lower sealed ball bearings
• Stainless steel shaft and fasteners
• Cast iron impeller
• 3-year warranty
Download Spec Sheet